Mobile phone masts

Rule of thumb: Look out your bedroom window. If there is a clear and unobstructed view of a mobile phone mast facing your way within a distance of about 300 meters go to:

www.emfields.org  who sell and advise on various screening products.  (01353 778814)

If you look out your window but can’t see the masts because they are obstructed by other buildings then the power density will be mainly absorbed by those buildings and too low to worry about.

Go to www.sitefinder.ofcom.org.uk  and put your post code in the box.  Your street will come up with the location of all the near-by mobile phone masts marked as blue triangles.

Electrosmog from neighbours

Paint the party or offending wall with carbon paint from :

www.emfields.org  to reflect it back.

Substations

If the substation is immediately next to your home there is little in a practical sense you can do to reduce the magnetic fields. Hire a meter from : www.emfields.org  and check out the field levels.

Unless the substation is immediately adjacent to your house the EMF’s from these small street substations fall to background levels within about 3 meters.

Overhead electricity pylons.

EMF’s from power lines are likely to drop below 0.2 microtesla [200 nanotesla] level at about:

·         150 meters from 400 kv lines

·         120 meters from 275 kv lines

·         100 meters from 132 kv lines

·         50 meters from 66 kv lines

·         30 meters from 33 kv lines

·         15 meters from 11 kv lines

DECT cordless phones.

Emit radiation 24 hours a day even when you are not using them.

Change them for ordinary land line phones. Or if you are addicted to cordless phones by the low energy Eco friendly types that only emit a signal when you are using them.  www.emfields.org

Sell the Orchid eco friendly phone or buy a Siemens Gigaset S675 which does the same thing.

WI-FI

WI-FI and DECT phones are overwhelmingly the main contributors to household electro pollution with power densities far above any nearby mobile phone mast.

If your internet connection is by telephone you will need the Netgear DG834 model opposite.

If your internet connection is via a cable connection you would need the Linksys wired modem opposite. There are other wired not WI-FI modems available ask your internet supplier.

You don’t need WI-FI in the home, school or office.  A far more efficient and environmentally friendly set-up would be to buy a hard wired router such as a Linksys Cable/DSL Router or Netgear ADLS2 Modem Router with 4 port 10/100 Mbps Switch DG834 with telephone connection) together with a dLan High speed Ethernet Installation starter kit from:

 www.devolo.com .  This will enable you to route the internet signal through your house ring circuit enabling you to use as many computers a you want from any room with full internet connection without the WI-FI. Sounds complicated but is surprisingly inexpensive simple to set up and use.

Digital Baby Alarms.

Nearly all baby monitors are now Digital.  If you go to my website : www.royriggs.co.uk  and click on Baby Monitors on my home page you will find a couple of recommendations where you can still get non digital baby alarms. Will do the same thing without the microwaves.

These alarms use the same technology as DECT cordless phones and will continuously pulsate microwave energy throughout the baby’s room and beyond.

Transformers

Bedside clocks usually have the transformers inside the the clock housing.  Most others, usually black look like big 3 point plugs and are hot to touch. Make sure all transformers are at least two feet away from you body.

The job of a transformer is to convert high voltage to low voltage. An example of this is a digital bedside alarm clock that only need 6 volts to operate but plugged into your 240 volt ring circuit. The 234 volts that it doesn’t need is radiated out as energy and heat.

TV and Computer screens

Best to change your old cathode-ray monitors (the ones with the deep backs) to any type of flat screen monitor as these give of far less Electromagnetic fields than the old type which thankfully you can’t buy any more.

Main ring & Lighting Circuits

In order to get your body back to its proper earth bound resonance you need to be sleeping earthed.  Explanation of what is sleeping earthed and how you can do it is found on my website. Click first on my ‘Student’s Notes’ button and scroll to the end for pictures and explanation. A more technical account is also on my website a blue button under my picture ‘ Sleeping Earthed’ for even more information. www.royriggs.co.uk

Your body voltage is highest where you sleep.

Naturally your body voltage should be in harmony and in equilibrium with the earth’s natural Schumann based electrical field, which is under 350 mV and normally stable at about 2 mV.  Average person sleeps with a body voltage of about 2,500 mV or more.

Following all the above advice will make an immense difference to you and your families health.

Mattress:    www.abacaorganic.co.uk

01269 598490 Code ‘Roy’ = 10% discount